Moonlit Flora Angled Tri-Fold Card

Supplies needed:

Project Recipe:

1. Measurements:
   Card Base (Peaceful Pine): 5 1/2" x 4 1/4"
   Mats (Golden Glow): Cut 3- 2 5/8" x 3 7/8"
   Focal Panels (Basic White): cut 3- 2 1/2" x 3 3/4"
   DSP Base (Moonlit Flora): 8 1/2" x 3 1/2" scored at 4" & 8"
   DSP Back Layer (Moonlit Flora): 5 1/4" x 4"
   DSP Middle Panel (Moonlit Flora): cut 2- 3 1/4" x 4 1/2"

2. Instructions:
   -Burnish score lines on the DSP Base to create a z-fold
   -Cut the DSP Base from the 8" score mark to the far edge at an angle. (Tip: Any angle will work, but I placed the tip of the DSP at 1 1/4")
   -Adhere the DSP Back Layer to the small end panel of the DSP Base.
   -Adhere the DSP Back Layer to the Card Base.
   -Adhere the DSP Middle Panels back-to-back on each side of the center section of the DSP Base.
   -Stamp or decorate the Focal Panels and adhere to the Mats.
   -Adhere one of the Matted Focal Panels to the center of the back panel
   -Adhere one of the Matted Focal Panels to the center section of the DSP Base so that it is facing the back panel
   -Adhere the last Matted Focal Panel to the front of the card

   Video instructions: https://youtube.com/live/8eWuF_CkrY0